DIY Party Glitter Pump

The following is a guest post from our friends at I Spy DIY.

December is officially here which means that holiday party season is upon us! For my December I tried out the absolutely amazing Krylon Glitter Blast to bedazzle a pair of pumps. I was blown away by how easy it was to use. I wonder if I could cover a wall in my room with this…too much? Never.

Glitter SpraysRed Pumps

Supplies: Pumps (I found these for $25) and Krylon Glitter Blast and Clear Sealer

DIY Glitter Pumps Step 1

Place Strips of masking tape over the body of the shoe so only the heel is left uncovered.

DIY Glitter Pumps Step 2

Hold the can of Gold Glitter Blast eight inches from the heel and spray. Let dry for 10 minutes, then repeat. Once the second layer of glitter is dry, spray sealant on the heel.

Allow to set overnight, then remove tape.

DIY Glitter Pumps

Sponsored Content

Leave a Reply

Your email address will not be published. Required fields are marked *